***
***
*** PLEASE REMEMBER: Always reboot the device first before you proceed with firmware upgrade.
***
***

2006-05-23 Version 3.29R3 <firmware_5xli@osbridge.com>

- Fixed bug where device until certain circumstances reverts to factory default settings after configuration change.

2006-07-14 Version 3.30R <firmware_5xli@osbridge.com>

- Added MSCHAP, CHAP and MPPE/MPPC authorization types for PPPoE connection.
- Added Last Good Config feature.
- Added support for WPA-CCMP (AES) encryption.
- Greatly improved QOS features to allow low latency (ie. VOIP) traffic prioritization.
- Added Remote Syslog feature which allows local events logged to remote syslog server.
- Added CLI. CLI (Command Line Interface) works on port 23 and is available via telnet. CLI is currently in early development stage so any suggestions or opinions will be appreciated.

2006-08-30 Version 3.30R3 <firmware_5xli@osbridge.com>

- Fixed antenna port problem on OSBRiDGE 900XL units.

2006-09-11 Version 3.31R <firmware_5xli@osbridge.com>

- Added Carrier Sense option which allows disabling standard CSMA Backoff Mechanism to greatly improve device performance in areas having noise from non 802.11a conformant systems (like Motorola Canopy or other proprietary 5GHz equipment).
- Added PPtP Client.
- Added ability to disable bridge forwarding if no PPPoE connection has been established (in IP bridge mode).

2006-09-25 Version 3.31R2 <firmware_5xli@osbridge.com>

- Fixed bug causing the device crash when operating in PtP Master mode and using certain combination of supported and fixed data rates. If you are using the device in PtP bridge mode it is highly recommended to commit this firmware upgrade.
- Added small antenna alignment tool.
- Added connection Speed Test tool.

Please note - if you are upgrading from firmware 3.30x or lower and use built-in PPPoE client then please disable it first before firmware upgrade.



--------------------------------------------------------

Should the OSBRiDGE device fail or loose power during firmware upgrade the built-in bootloader allows easy firmware restore.

Indication of the device requiring firmware restore is WLAN and Ethernet LEDs blinking subsequentialy for 10 seconds immediately after device power up. Please note however that the LEDs may not always blink when firmware restore is required.

The procedure required to perform:

1. You need to obtain tftp server software, the free one is available at http://tftpd32.jounin.net/
2. Install tftpd32.exe into the catalog where firmware files are located
3. Rename the firmware file into osbridge_5xli.bin
4. Change your computer IP address to 192.168.1.23 netmask 255.255.255.0
5. Connect the OSBRiDGE device to the computer via cross-over cable or via network switch
6. Turn on the OSBRiDGE device, it will initiate the transfer automaticaly, reflash and reboot itself.

---------------------------------------------------------

